Fault finder: Fume extractor with interlock

12 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Tool never allowed: what should I check?

Measure the fan current; if it is below 0.08 A lower MIN_FAN_AMPS or check the fan runs through the ACS712.

Current reads half an amp with the fan off: what should I check?

The sensor was powered while measuring zero, so restart the Nano with the fan wires connected but off.

Readings jump around: what should I check?

Keep the signal wire from A0 away from the relay and fan wires.

Relays work the wrong way round: what should I check?

Your board switches on with HIGH, so swap the HIGH and LOW writes.

Nano resets when the relays click: what should I check?

Add a 100 uF capacitor across the Nano power and keep the converter wires short.