Fault finder: Solder fume extractor

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Fan will not start slowly: what should I check?

Raise the minimum speed on the controller.

Weak pull: what should I check?

Move the fan closer to the work and check the filter fit.

Controller hot: what should I check?

Use a smaller fan or a larger controller.

Smell persists: what should I check?

Replace the carbon filter and ventilate.