Fault finder: Pressure pad door chime
6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Always chimes: what should I check?
Raise THRESHOLD or check the 10 kilohm resistor is to GND.
Never chimes: what should I check?
Lower THRESHOLD and check the FSR legs are in the right rows.
Readings jump around: what should I check?
Add a 100 nanofarad capacitor from A0 to GND.
Buzzer stays on: what should I check?
Check its wiring and that it is an active buzzer.
Pad stops working: what should I check?
The thin legs may have been bent, replace the sensor.
