Fault finder: Gain of three small NPN transistors
5 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Collector voltage near 9 V: what should I check?
Transistor is off or in backwards, check the pinout.
Collector voltage near 0 V: what should I check?
The gain is very high or the base resistor is too small.
Gain very low: what should I check?
Pin order wrong, swap the legs.
Readings drift: what should I check?
Hold the transistor steady and let it settle.
Voltage across 330 ohm is zero: what should I check?
Check the base resistor chain.
