Fault finder: Light sensor fault hunt

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Readings never change: what should I check?

The LDR may not be in the divider, so check both legs.

Always zero: what should I check?

Check the LDR leg to 5 V.

Always full: what should I check?

Check the resistor goes to GND, not 5V.

Numbers noisy: what should I check?

Keep the wires short and check the ground end.

Meter and sketch disagree: what should I check?

Check the meter is on DC volts and the probe is on A0.