Fault finder: Temperature probe fault hunt

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always -127 even when wired correctly: what should I check?

Check the sensor is the 3-wire probe and the wire colours match yours.

Reading stuck at 85: what should I check?

Check the power wire and keep the data wire short.

Sensor gets hot: what should I check?

Disconnect at once and check the power is the right way round.

No serial text: what should I check?

Set 9600 baud in the monitor.

Library errors: what should I check?

Install both libraries.