Fault finder: Engine temperature alarm

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading is always 0 or NaN: what should I check?

The probe is not connected or wired backwards at the module.

Reading jumps around: what should I check?

Electrical noise from the engine. Shield or twist the probe wires and add 100 µF on the 5 V rail.

LCD blank: what should I check?

Check the address 0x27 or 0x3F and contrast trimmer.

Nano resets when the engine cranks: what should I check?

The supply sags. Add a 470 µF capacitor at the buck input.