Fault finder: Electronic dice with a 7-segment display

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Display is blank: what should I check?

Check pin 4 BI is joined to 5V and the display common goes to GND.

Wrong digits: what should I check?

Swap the order of the four number wires, A must be the smallest bit on pin 7.

Digit shows odd shapes: what should I check?

The segment wires are in the wrong order, so check them against a to g.

Digit is dim: what should I check?

Use 220 ohm resistors instead of 330 ohm.

Same numbers every time: what should I check?

Keep randomSeed and leave A0 unconnected.