Fault finder: Programmable bench supply with DPS5005

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output too low: what should I check?

Check the input voltage and the current limit.

Module gets hot: what should I check?

Add vents and lower the load.

Display dead: what should I check?

Check input polarity and the fuse.