Projects / Diode basics lab / Fault finder

Fault finder: Diode basics lab

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reads zero both ways: what should I check?

The diode is shorted or you used the continuity mode. Use diode mode.

Reads OL both ways: what should I check?

The diode is open or the probes are not touching.

LED does not light: what should I check?

Check the LED direction and the diode direction.

Reading differs a lot from the table: what should I check?

Your meter's test current differs. Compare the diodes with each other.