Fault finder: 3-to-8 decoder selector

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

All LEDs on or none: what should I check?

An enable pin is wrong. Check pins 4, 5 and 6.

Two LEDs light: what should I check?

An address pin is floating. Add a pull-down.

LED order looks wrong: what should I check?

Y7 is on pin 7, which is out of sequence. Check the pin list.

Nothing lights: what should I check?

LEDs are backwards or power is off.