Fault finder: Current divider ammeter lab

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Meter reads zero: what should I check?

Check the red probe is in the mA socket and the fuse is good.

Values are a little low: what should I check?

The meter adds a small resistance, which lowers the current slightly.

Meter fuse blown: what should I check?

Replace it with the same type and rating, and keep the meter only in series.

Currents do not add up: what should I check?

A branch may be loose, so check each resistor leg.

Display shows OL: what should I check?

Choose a higher range.