Fault finder: Exam countdown timer
10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Time runs fast or slow: what should I check?
Do not use delay() long in the loop. Keep the main loop free.
Buttons ignored: what should I check?
The wiring is on the wrong pins or the buttons are bouncing. Check D4 to D6.
Display blank: what should I check?
CLK and DIO may be swapped.
Wrong digits: what should I check?
Use showNumberDecEx with the colon mask as in the code.
