Fault finder: Coin-cell LED badge
9 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
LED never lights: what should I check?
Check its direction, the long leg goes to the resistor.
Very dim: what should I check?
The cell may be flat, measure it, a good cell reads about 3 V.
Cell warm: what should I check?
Something is shorting it, remove it at once.
Blue or white LED does not light: what should I check?
It needs more than 3 V, use red or yellow.
Button feels stuck: what should I check?
Use a different button.
