Fault finder: Make a set of clip test leads

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Joint is dull and grainy: what should I check?

Reheat and add a little fresh solder, hold still while it cools.

Tubing does not fit: what should I check?

It must be slid on before soldering.

No beep: what should I check?

Reheat the joint or recheck the stripped strands.

Strands poke out: what should I check?

Twist them tightly and trim any stray ones.

Wire insulation melted: what should I check?

The iron touched it, let it cool and recut.