Fault finder: Slow blinker with a counter chip

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never changes: what should I check?

Reset on pin 12 must go to GND.

Fast flicker instead of slow: what should I check?

You are on a low-numbered output, use pin 1, 2 or 3.

Oscillator does not run: what should I check?

Check the junction and the order of pins 9, 10 and 11.

LED very dim: what should I check?

Normal at 5 V with a 1 kohm resistor.

Times far off: what should I check?

The capacitor value differs from the label, measure and adjust.