Fault finder: Garage car door ajar alarm

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Alarm with the door closed: what should I check?

The magnet is too far from the reed switch.

Never beeps: what should I check?

OPEN_LIMIT is long or the reed switch wire is not on D2.

Beeps too quietly: what should I check?

Use an active buzzer with more volume or a small speaker driver.

Snooze ignored: what should I check?

Check the button wires to D3 and ground.