Projects / Capacitance meter / Fault finder

Fault finder: Capacitance meter

6 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

The LCD is blank: what should I check?

Turn the contrast trimmer on the backpack, and try address 0x3F.

Readings are always about 5 to 10 % off: what should I check?

Measure the 10 kΩ resistor with a multimeter and put the real value in R_CHARGE.

Small capacitors read nonsense: what should I check?

Under 1 µF the charge time is only microseconds. This build is for larger values.

It never finishes: what should I check?

The capacitor may be leaky or a very large value. The sketch gives up after 20 seconds.