Fault finder: Voltage and resistor reference board

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output wrong: what should I check?

Check the reference pin connection.

Output unstable: what should I check?

Remove any capacitor from the output.

Meters disagree: what should I check?

Check battery and leads, then re-measure.

Reference drifts: what should I check?

Allow time to warm up and use a fresh battery.