Fault finder: Active and passive buzzer tour

6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No sound from either: what should I check?

Check the plus pin direction and the wires to D8 and D9.

Passive buzzer silent on the scale: what should I check?

It may actually be an active type, so compare with step 1.

Active buzzer clicks only: what should I check?

It may be a passive type.

Too loud: what should I check?

Add a 100 ohm resistor in series.

Serial text garbled: what should I check?

Set the monitor to 9600 baud.