Fault finder: Button contact bounce counter

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing prints: what should I check?

Set 115200 baud in the monitor.

Counts rise with no press: what should I check?

Check the button is wired to GND and D2 only.

Raw equals clean: what should I check?

Your button may be a clean one, try another.

Counts jump by two: what should I check?

Press and release evenly.

Upload fails: what should I check?

Choose the Old Bootloader option.