Fault finder: Model bus stop request sign

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No chime: what should I check?

Check you have a passive buzzer on D10.

Chime plays more than once: what should I check?

Check the latch logic, buttons should be ignored while stopping.

Sign never clears: what should I check?

Check the reset button goes to D5 and GND.

LED stays dark: what should I check?

Check its direction and its resistor.

Nothing happens at all: what should I check?

Check each button goes to its pin and GND.