Fault finder: Bluetooth home automation with four relays

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Relays switch the opposite way: what should I check?

Your board is active-high. Change ON to HIGH.

Relays chatter or the Uno resets: what should I check?

Four coils draw about 300 mA. Power the relay board's JD-VCC from a separate 5 V supply and remove its jumper.

Phone shows nothing back: what should I check?

Check the D3 divider goes to HC-05 RXD.

Mains loads: what should I check?

Mains wiring must be done by a qualified electrician in a closed, earthed box with fuses. Learn with 12 V loads.