Fault finder: Blue Pill weather node

10 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

BME280 not found: what should I check?

Check SDA, SCL and the 3.3 V supply, and the module is a BME280 and not a BMP280.

No serial output: what should I check?

Check USB support is set to CDC, and the port is selected.

Temperature reads high: what should I check?

Move the sensor away from the board and the regulator.

Garbled text: what should I check?

Set the monitor to 115200.

Upload fails: what should I check?

Check the ST-Link wires and boot jumpers.