Fault finder: Transistor saturation and base resistor lab

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never lights: what should I check?

Check the transistor pins: flat face, then collector, base, emitter from the left on most BC547s.

LED always bright: what should I check?

The base resistor is too small, or the base is touching the supply.

Vce looks stuck at 9 V: what should I check?

The base resistor may not be connected to the base.

Transistor gets hot: what should I check?

Stop and recheck, since the load should be only about 14 mA.

Readings vary: what should I check?

Gain differs between transistors, so test your own.