Fault finder: Bicycle speedometer and odometer

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Speed reads zero while turning: what should I check?

The magnet is too far or the wrong pole faces the sensor. Flip it and bring it to 3 mm.

Speed is double or half: what should I check?

Two magnets or a missed pulse. Check mounting, or change WHEEL_MM only after fixing that.

Display glitches on bumps: what should I check?

Secure the wires and add a 100 nF capacitor at the display.

The sensor chip gets hot: what should I check?

It is in backwards. Check pin 1 is VCC and the flat face is towards the magnet.