Fault finder: 18650 battery capacity tester

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Current reads zero: what should I check?

The gate is not high. Check D4 and the MOSFET orientation.

Result is far off: what should I check?

R_LOAD or VREF are not your measured values.

Resistor too hot: what should I check?

Mount it away from other parts and in free air. It is a 5 W part at under 2 W, but it still gets hot.

Test never starts: what should I check?

The cell is below the minimum starting voltage. Charge it first.