Fault finder: Automatic plant watering system

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

The pump runs all the time: what should I check?

Your relay may switch on with HIGH. Change RELAY_ON to HIGH.

Readings jump around: what should I check?

Push the sensor to the same depth each time and keep the electronics above the line dry.

The pump hums but no water: what should I check?

Prime it under water and check the tube is not kinked.

Watering every minute: what should I check?

DRY is too low for your soil. Recalibrate.