Fault finder: MKR WiFi 1010 signal strength meter

9 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Stays on Joining Wi-Fi: what should I check?

Check the name and password, and that the network is 2.4 GHz.

Display blank: what should I check?

Check the I2C wires on pins 11 and 12 and the address 0x3C.

Does not compile: what should I check?

Install the WiFiNINA library and the SAMD board package.

Number jumps around: what should I check?

This is normal, watch the trend, not each value.

Firmware warning: what should I check?

Update the Wi-Fi firmware with the Arduino IDE's updater tool if asked.