Fault finder: 555 timer LED flasher
8 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
LED stays on or off: what should I check?
Pin 4 not tied to plus, or pins 2 and 6 not joined.
Much slower than expected: what should I check?
Electrolytic capacitors are often +20 % or more. Measure with a capacitance meter.
Gets warm: what should I check?
The 555 or LED is backwards. Check the notch and the LED's long leg.
