Fault finder: Design a 3D printed enclosure

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Board does not fit: what should I check?

Add 0.1 mm clearance and reprint.

Holes too small: what should I check?

Open them by 0.2 mm in the model.

Lid loose: what should I check?

Make the lip thicker by 0.1 mm.

Warping: what should I check?

Use a brim and print away from drafts.