OV7670 camera module
Low-cost VGA camera module without a frame buffer.
MeasuresImage up to 640 × 480
InterfaceParallel 8-bit plus SCCB
Supply voltage3.3 V
Watch out forHard to use on an Uno; an ESP32-CAM is easier
SensorsReviewedMPN OV7670
In short
What is the OV7670 camera module and what is it used for?
Low-cost VGA camera module without a frame buffer. Makers use it for learning camera interfaces.
How it works
A CMOS image sensor outputs raw pixel data in parallel.
Key specifications
| Sensor spec | Value |
|---|---|
| Measures | Image up to 640 × 480 |
| Interface | Parallel 8-bit plus SCCB |
| Supply voltage | 3.3 V |
| Watch out for | Hard to use on an Uno; an ESP32-CAM is easier |
Pinout
3V3Supply
GNDGround
SIOC and SIODSCCB control (like I2C)
VSYNC and HREFFrame and line sync
PCLKPixel clock
XCLKClock input from your board
D0 to D7Pixel data
RESET and PWDNControl
How to use it
It needs a fast clock and 8 data pins, so it suits ESP32 or STM32 boards, not an Uno. For beginners, an ESP32-CAM is much easier.
Applications
Learning camera interfaces
Builds that use it
Not used in a published project yet.
Alternatives
- OV2640 camera moduleJPEG output, used on ESP32-CAM
- ESP32-CAMCamera plus Wi-Fi on one board
Common questions
What is the OV7670 camera module used for?
In maker projects: learning camera interfaces.
How does the OV7670 camera module work?
A CMOS image sensor outputs raw pixel data in parallel.
What voltage does the OV7670 camera module need?
3.3 V.
How do I connect the OV7670 camera module to an Arduino or ESP32?
Parallel 8-bit plus SCCB. Pins: 3V3 (Supply), GND (Ground), SIOC and SIOD (SCCB control (like I2C)), VSYNC and HREF (Frame and line sync), PCLK (Pixel clock), XCLK (Clock input from your board).
What can I use instead of the OV7670 camera module?
OV2640 camera module and ESP32-CAM.
