NEO-6M GPS + SIM800L tracker board
Combined GPS and GSM board for vehicle trackers.
RadioGSM 2G + GPS
InterfaceUART
Supply voltage5 V
Watch out for2G coverage varies
WirelessReviewedMPN GPS GSM board
In short
What is the NEO-6M GPS + SIM800L tracker board and what is it used for?
Combined GPS and GSM board for vehicle trackers. Makers use it for vehicle trackers.
How it works
A u-blox NEO-6M GPS receiver and a SIM800L modem on one board.
Key specifications
| Wireless module spec | Value |
|---|---|
| Radio | GSM 2G + GPS |
| Interface | UART |
| Supply voltage | 5 V |
| Watch out for | 2G coverage varies |
Pinout
5VSupply
GNDGround
GPS TX RXNMEA at 9600 baud
GSM TX RXAT commands
AntennasGPS patch and GSM
How to use it
Read position with TinyGPS++ and send it by SMS or GPRS with TinyGSM. Place the GPS antenna with a clear view of the sky. The GSM side is 2G only, so it will not work on Jio.
Applications
Vehicle trackers
Builds that use it
Not used in a published project yet.
Alternatives
- GPS module NEO-6MGPS alone
- SIM7600 4G LTE module4G with GPS built in
Common questions
What is the NEO-6M GPS + SIM800L tracker board used for?
In maker projects: vehicle trackers.
How does the NEO-6M GPS + SIM800L tracker board work?
A u-blox NEO-6M GPS receiver and a SIM800L modem on one board.
What voltage does the NEO-6M GPS + SIM800L tracker board need?
5 V.
How do I connect the NEO-6M GPS + SIM800L tracker board to an Arduino or ESP32?
UART. Pins: 5V (Supply), GND (Ground), GPS TX RX (NMEA at 9600 baud), GSM TX RX (AT commands), Antennas (GPS patch and GSM).
What can I use instead of the NEO-6M GPS + SIM800L tracker board?
GPS module NEO-6M and SIM7600 4G LTE module.
