Components / Sensors / Maxbotix MB1010 ultrasonic sensor
Sensors

Maxbotix MB1010 ultrasonic sensor

Ultrasonic sensor with analog, PWM and serial outputs.

DistanceMeasures
0 to 6.45 m (reports 15 cm minimum)Range
Analog, PWM, serialInterface
2.5 to 5.5 VSupply voltage
ReviewedMade by MaxBotixMPN MB1010 LV-EZ1Used in 1 project
Get this part
In short

What is the Maxbotix MB1010 ultrasonic sensor and what is it used for?

Ultrasonic sensor with analog, PWM and serial outputs. Makers use it for reliable distance.

How it works

An ultrasonic transducer with on-board processing that filters out noise.

Key specifications

Sensor specValue
MeasuresDistance
Range0 to 6.45 m (reports 15 cm minimum)
InterfaceAnalog, PWM, serial
Supply voltage2.5 to 5.5 V

Pinout

GNDGround
+52.5 to 5.5 V
TXSerial output
RXHold low to stop ranging
ANAnalog, Vcc/512 per inch
PWPulse width, 147 µs per inch
BWChain mode

How to use it

The analog output is the easiest: inches = voltage ÷ (Vcc/512). It reads 6 inches (15 cm) for anything closer.

Applications

Alternatives

Buy at

Common questions

What is the Maxbotix MB1010 ultrasonic sensor used for?

In maker projects: reliable distance.

How does the Maxbotix MB1010 ultrasonic sensor work?

An ultrasonic transducer with on-board processing that filters out noise.

What voltage does the Maxbotix MB1010 ultrasonic sensor need?

2.5 to 5.5 V.

How do I connect the Maxbotix MB1010 ultrasonic sensor to an Arduino or ESP32?

Analog, PWM, serial. Pins: GND (Ground), +5 (2.5 to 5.5 V), TX (Serial output), RX (Hold low to stop ranging), AN (Analog, Vcc/512 per inch), PW (Pulse width, 147 µs per inch).

What can I use instead of the Maxbotix MB1010 ultrasonic sensor?

HC-SR04 Ultrasonic Sensor.