MAX4466 microphone module
Electret microphone with an adjustable amplifier. Analog output.
MeasuresSound (audio waveform)
RangeGain 25× to 125×, set with the trimmer
AccuracyNot calibrated in dB; good for relative loudness
InterfaceAnalog, centred at VCC/2
SensorsReviewedMPN MAX4466 electret moduleUsed in 24 projects
In short
What is the MAX4466 microphone module and what is it used for?
Electret microphone with an adjustable amplifier. Analog output. Makers use it for noise trend logger.
In the real world
Clap switches, sound level meters
How it works
The amplifier turns tiny microphone voltages into a signal centred at half the supply.
Key specifications
| Sensor spec | Value |
|---|---|
| Measures | Sound (audio waveform) |
| Range | Gain 25× to 125×, set with the trimmer |
| Accuracy | Not calibrated in dB; good for relative loudness |
| Interface | Analog, centred at VCC/2 |
| Supply voltage | 2.4 to 5.5 V |
| Operating temperature | −40 to 85 °C |
Pinout
VCC3.3 V (quieter) or 5 V
GNDGround
OUTAnalog audio, to an ADC pin
How to use it
Measure peak-to-peak over a short window (about 50 ms) to get loudness. Power it from 3.3 V on an ESP32 so the output never exceeds the ADC range.
void setup() { Serial.begin(115200); }
void loop() {
int lo = 4095, hi = 0; unsigned long t = millis();
while (millis() - t < 50) { int v = analogRead(34); lo = min(lo, v); hi = max(hi, v); }
Serial.println(hi - lo);
}Applications
Sound level trendsClap switches
Builds that use it
Guided build
Noise trend logger
Guided build
Music-reactive LED strip
Guided build
Sound-reactive LED costume
Guided build
Cooker whistle counter
Guided build
Microphone noise floor and gain lab
Idea
Thunderstorm light-flash counter
Idea
Local language model assistant
Idea
Sound direction finder
Showing 8 of 24
Common questions
What is the MAX4466 microphone module used for?
In products: clap switches, sound level meters. In maker projects: noise trend logger.
How does the MAX4466 microphone module work?
The amplifier turns tiny microphone voltages into a signal centred at half the supply.
What voltage does the MAX4466 microphone module need?
2.4 to 5.5 V.
How do I connect the MAX4466 microphone module to an Arduino or ESP32?
Analog, centred at VCC/2. Pins: VCC (3.3 V (quieter) or 5 V), GND (Ground), OUT (Analog audio, to an ADC pin).
