Components / Wireless / ESP-01 Wi-Fi Module

ESP-01 Wi-Fi Module

Compact ESP8266-based wireless module.

RadioESP8266EX Wi-Fi SoC
Band2.4 GHz 802.11 b/g/n
Typical rangeNormal home Wi-Fi range
InterfaceUART (AT commands) or run your own code on it
WirelessReviewedMPN ESP-01 / ESP-01SUsed in 1 project
ESP01
In short

What is the ESP-01 Wi-Fi Module and what is it used for?

Compact ESP8266-based wireless module. Makers use it for explore regulated 3.3 V supplies.

In the real world

Retrofit network connectivity

How it works

RF modules require power, antenna/interface matching and local wireless regulatory compliance.

Key specifications

Wireless module specValue
RadioESP8266EX Wi-Fi SoC
Band2.4 GHz 802.11 b/g/n
Typical rangeNormal home Wi-Fi range
InterfaceUART (AT commands) or run your own code on it
Supply voltage3.0 to 3.6 V, peaks around 300 mA
Logic level3.3 V only

Pinout

VCC / GND3.3 V with enough current (not the Uno's 3.3 V pin)
TX / RXUART
CH_PD (EN)Tie HIGH
RSTReset, tie HIGH
GPIO0LOW at boot to flash
GPIO2Spare I/O, keep HIGH at boot

How to use it

Awkward to breadboard and to flash. For new builds an ESP32 or an ESP8266 board like the NodeMCU or Wemos D1 mini is easier and similar in price.

// Flashed as its own board ("Generic ESP8266 Module")
#include <ESP8266WiFi.h>
void setup() { Serial.begin(115200); WiFi.begin("SSID", "PASSWORD"); }
void loop() { Serial.println(WiFi.status() == WL_CONNECTED ? WiFi.localIP().toString() : "…"); delay(1000); }

Applications

Alternatives

Buy at

Common questions

What is the ESP-01 Wi-Fi Module used for?

In products: retrofit network connectivity. In maker projects: explore regulated 3.3 V supplies.

How does the ESP-01 Wi-Fi Module work?

RF modules require power, antenna/interface matching and local wireless regulatory compliance.

What voltage does the ESP-01 Wi-Fi Module need?

3.0 to 3.6 V, peaks around 300 mA.

How do I connect the ESP-01 Wi-Fi Module to an Arduino or ESP32?

UART (AT commands) or run your own code on it. Pins: VCC / GND (3.3 V with enough current (not the Uno's 3.3 V pin)), TX / RX (UART), CH_PD (EN) (Tie HIGH), RST (Reset, tie HIGH), GPIO0 (LOW at boot to flash), GPIO2 (Spare I/O, keep HIGH at boot).

What can I use instead of the ESP-01 Wi-Fi Module?

ESP32 DevKit V1.