Workshop / PCB prototyping / Board files

Board files

Gerbers for our guided builds. Download the zip, check it, and order the boards from us.

Reviewed48 × 30 mm · 2 layers

I²C carrier board

Plugs the BME280 and the OLED into one board with the ESP32 wires, so nothing falls out of the breadboard. Two layers, through-hole only.

For Desk climate monitor. ESP32 socket: 3V3, GND, SCL (GPIO22), SDA (GPIO21). BME280: VIN, GND, SCL, SDA. OLED: GND, VCC, SCL, SDA.

Parts to solder (2)
  • 3 × 4-pin female header, 2.54 mm
  • 4 × M3 screws (optional)
Check itMake a box

Desk-checked design, not bench-tested yet.

Reviewed40 × 25 mm · 2 layers

LED and button board

One LED with its resistor and one push button, wired to a 3-pin header for GND, D9 and D2. Good first board to solder.

For LED and button controller. Header: GND, D9 (LED through 220 Ω), D2 (button to GND; use INPUT_PULLUP).

Parts to solder (4)
  • 1 × 5 mm LED
  • 1 × 220 Ω resistor
  • 1 × 6 mm push button
  • 1 × 3-pin male header
Check itMake a box

Desk-checked design, not bench-tested yet.

More boards are on the way. Have your own? Check its Gerbers.

Get it made by ElectroLark

Made in-house

We make the boards and post them to you: ₹1,500 a board for 1 or 2 samples up to 100 × 100 mm, + GST. More pieces or bigger boards get a quote.

Press Check it on a board, or open your own Gerbers in the Gerber check, and order from there.

Open the Gerber check