Workshop / ESP32 flasher

ESP32 flasher

Write a .bin to an ESP32 straight from your browser, with nothing to install. Handy on lab computers without Arduino IDE.

1. Connect the board

Plug the ESP32 in with a data USB cable, then pick its port. Close Arduino IDE's serial monitor first: only one program can use the port.

Not connected

2. Choose the firmware

Bootloader, partitions and your sketch in one file. Works on any ESP32 chip.

3. Write it

Common questions

Can I flash an ESP32 without the Arduino IDE?

Yes. Pick a .bin file and write it to the ESP32 over USB from Chrome or Edge. The file stays on your computer.

The ESP32 does not connect. What should I check?

Use a data USB cable, not a charge-only one, install the USB driver for the board's chip (CP2102 or CH340), and hold the BOOT button while it connects if it does not enter download mode by itself.