Tools / Current-Sense Shunt Resistor
How to work out a current shunt resistor
A small resistor in the current path turns current into a small voltage. An amplifier makes it big enough for an ADC.
Vsense = I·R; P = I²R
Result
- Shunt voltage
- 100 mV
- Shunt power
- 200 mW
- Amplifier output
- 2 V
What this leaves out
- Check the shunt power rating and the amplifier common-mode and supply limits. Use a qualified design for mains circuits.
Step by step
The working with your numbers
- Change milliohms to ohms
R = 50 mΩ ÷ 1000 = 0.05 Ω - Sense voltage
V = I × R = 2 × 0.05 = 100 mV - Power in the shunt
P = I² × R = 2² × 0.05 = 200 mW - Amplifier output
Vout = V × gain = 100 mV × 20 = 2 V
Does the answer make sense?
- OK: Pick a shunt rated 1/2 W or more.
- OK: 2 V fits a 3.3 V ADC input.
- OK: Only 100 mV is lost across the shunt.
Common mistakes
- Forgetting to change mΩ to Ω, making the voltage 1000 times too big.
- Wiring the shunt's ADC sense lines to the same pads as the high-current wires. Use separate sense connections (Kelvin) for accuracy.
- Ignoring the amplifier's offset, which matters most at small currents.
Learn it, try it, build it
Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.
Just need the number? Use the current-Sense shunt resistor calculator on Geekobot.
Common questions
How do you size a current shunt resistor?
Pick R so the full current gives a sense voltage of about 50 to 100 mV, then check P = I² × R. For 2 A, 50 mΩ gives 100 mV and burns 0.2 W.
Why amplify the shunt voltage?
Shunt voltages are tens of millivolts, a small part of an ADC's range. A current-sense amplifier with a gain of about 20 to 50 uses the full range for better resolution.
