Tools / PWM Timing Calculator

How to work out PWM on time and off time

PWM switches a pin fully on and off. The frequency sets how often; the duty cycle sets how much of each cycle is on.

Period = 1/f; Ton = D × period

Inputs

Hz
%

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Period
1 ms
On time
250 µs
Off time
750 µs
What this leaves out
  • Timer resolution, switching losses and driver suitability require specific hardware verification.
Step by step

The working with your numbers

  1. Find the periodT = 1 ÷ f = 1 ÷ 1,000 = 1 ms
  2. Change the duty cycle to a fractionD = 25 % ÷ 100 = 0.25
  3. On timeTon = D × T = 0.25 × 1 ms = 250 µs
  4. Off timeToff = T − Ton = 1 ms − 250 µs = 750 µs
See it

Three cycles of your PWM signal

OffOn0 s1 ms2 ms3 msTime
Pin against time. Each cycle lasts 1 ms; the pin is on for 250 µs of it.

Does the answer make sense?

  • OK: Ton + Toff = 1 ms, one full period.
  • OK: 1 kHz is fine for LEDs. For motors, frequencies under 20 kHz can whine audibly.

Common mistakes

  • Thinking a higher duty cycle changes the frequency. It only changes how the period is split.
  • Using analogWrite() for a servo. Arduino's analogWrite runs at about 490 Hz (980 Hz on some pins); servos need 50 Hz pulses from the Servo library.
  • Driving a motor straight from a pin. A pin gives about 20 mA; use a transistor or MOSFET and a flyback diode.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Just need the number? Use the PWM timing calculator on Geekobot.

Common questions

How do you work out PWM on time?

Find the period T = 1 ÷ f, then multiply by the duty cycle as a fraction. At 1 kHz and 25 %: T = 1 ms, so the pin is on for 0.25 ms and off for 0.75 ms.

What PWM frequency should I use for LEDs?

Anything above a few hundred hertz looks steady to the eye. Arduino's default of about 490 Hz is fine for indicator LEDs.