Tools / PCB Trace Width (IPC-2221, external)

How to work out PCB trace width for a current

A trace heats up as current flows. The IPC-2221 formula finds the copper area, and the copper thickness turns that into a width.

A(mil²) = (I / (k·ΔT^0.44))^(1/0.725), k = 0.048 external

Inputs

A
°C
oz

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Trace width (mm)
0.3003762
Trace width (mil)
11.82584
Inner layer width (mm)
0.7814107
What this leaves out
  • IPC-2221 external-layer estimate for a trace in air; inner layers need about twice the width. Check your fab rules and voltage clearance.
Step by step

The working with your numbers

  1. Copper area in square milsA = (I ÷ (0.048 × ΔT^0.44))^(1 ÷ 0.725) = (1 ÷ (0.048 × 10^0.44))^1.379 = 16.3 mil²0.048 is the IPC-2221 constant for outer layers; inner layers use 0.024 and need about twice the width.
  2. Copper thickness1 oz × 1.378 mil = 1.38 mil
  3. WidthW = A ÷ thickness = 16.3 ÷ 1.38 = 11.8 mil = 0.3 mm

Does the answer make sense?

  • OK: Round up to a width your fab can make reliably, for example 0.4 mm.
  • OK: A 10 °C rise is a common, conservative choice. Allowing 20 °C makes traces narrower but hotter.
  • OK: Wide traces also lower voltage drop, which helps motor and LED supplies.

Common mistakes

  • Using the outer-layer formula for inner layers, which run hotter for the same width.
  • Forgetting that 1 oz copper is about 35 µm (1.378 mil) thick.
  • Sizing for the average current when the peak current is much higher.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Common questions

How wide should a PCB trace be for 1 A?

With 1 oz copper on an outer layer and a 10 °C rise, IPC-2221 gives about 0.3 mm (12 mil). Inner layers need about twice that.

Where does the PCB trace width formula come from?

It is the IPC-2221 chart fit: I = k × ΔT^0.44 × A^0.725, with k = 0.048 for outer layers and A in square mils.