Tools / Op-amp bandwidth and slew rate

How to check an op-amp's bandwidth and slew rate

An op-amp does not amplify every frequency equally. Two limits matter: how much gain it has at your frequency, and how fast its output can move.

f(−3 dB) = GBW ÷ gain; fmax = SR ÷ (2π × Vpeak)

Inputs

×
MHz
V/µs
V

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Small signal bandwidth
300 kHz
Full power bandwidth
413.8 kHz
Usable frequency
300 kHz
Limited by
gain-bandwidth product
Step by step

The working with your numbers

  1. Change the datasheet unitsGBW = 3 MHz = 3 MHz, SR = 13 V/µs = 13,000,000 V/s
  2. Small-signal bandwidth (−3 dB point)f(−3 dB) = GBW ÷ gain = 3 MHz ÷ 10 = 300 kHzThe product of gain and bandwidth stays roughly constant.
  3. Full-power bandwidth from slew ratefmax = SR ÷ (2π × Vpeak) = 13,000,000 ÷ (2π × 5) = 414 kHzA sine of that amplitude and frequency changes at exactly the slew rate at its steepest point.
  4. The lower of the two is the limitusable ≈ 300 kHz (bandwidth limits first)

Does the answer make sense?

  • OK: Gain-bandwidth limits first. A smaller gain or a faster op-amp raises the usable frequency.
  • OK: Allow margin: by the −3 dB frequency the output is already 29 % down, so work at a fifth to a tenth of it if you want accuracy.

Common mistakes

  • Reading GBW as the bandwidth at any gain. It is the frequency where the gain falls to 1.
  • Forgetting that slew rate depends on amplitude. A small signal can pass at a frequency where a large one is distorted.
  • Using a datasheet's typical figure as a guaranteed one. Leave a margin of two.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Common questions

What is the gain-bandwidth product of an op-amp?

The frequency at which the open-loop gain falls to 1. For a voltage-feedback op-amp, closed-loop gain × closed-loop bandwidth is about constant and equal to it.

What is slew rate and why does it distort a signal?

It is the fastest the output can change, in V/µs. A large, fast sine needs a steeper slope than the amplifier can give, so its peaks are cut into straight lines.