Tools / Frequency ↔ Period

How to work out the period from frequency

Frequency counts cycles each second; the period is how long one cycle lasts. Each is one divided by the other.

T = 1 / f

Inputs

Hz

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Period
1 ms
Period
1 ms
Angular frequency
6.283 ks
Step by step

The working with your numbers

  1. Write the ruleT = 1 ÷ ff in hertz (cycles per second) gives T in seconds.
  2. Put in your frequencyT = 1 ÷ 1,000 = 1 ms
  3. Half a periodT ÷ 2 = 500 µsA 50 % square wave is high for half the period and low for the other half.

Does the answer make sense?

  • OK: Check it backwards: 1 ÷ 1 ms = 1 kHz.
  • OK: Higher frequency always means a shorter period: double f and T halves.

Common mistakes

  • Mixing kHz and Hz. 1 kHz is 1,000 Hz, so its period is 1 ms, not 1 s.
  • Reading the time between two edges of the same direction as half a period. Rising edge to the next rising edge is one full period.
  • Confusing angular frequency ω = 2πf (rad/s) with f in hertz.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Just need the number? Use the frequency ↔ period calculator on Geekobot.

Common questions

How do you convert frequency to period?

Divide 1 by the frequency in hertz: T = 1 ÷ f. A 1 kHz signal has a period of 1 ÷ 1,000 = 1 ms, and 50 Hz mains has a period of 20 ms.

What is the period of a 16 MHz clock?

1 ÷ 16,000,000 = 62.5 ns. That is the time for one tick of an Arduino Uno's crystal.