Tools / Series / Parallel Capacitors

How to work out capacitors in series and parallel

Capacitors combine the opposite way to resistors: parallel adds up, series gets smaller.

Cparallel = C1+C2; Cseries = C1C2/(C1+C2)

Inputs

µF
µF

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Equivalent
32 µF
Connection
parallel
What this leaves out
  • Voltage ratings, balance resistors and polarity for electrolytic capacitors are not checked.
Step by step

The working with your numbers

  1. In parallel the plates add upC = C1 + C2 = 10 + 22 = 32 µFParallel capacitors act like one capacitor with a bigger plate area.

Does the answer make sense?

  • OK: Parallel total 32 µF is bigger than either capacitor.
  • OK: Each capacitor sees the full voltage, so both need a rating above it.

Common mistakes

  • Using the resistor rules. For capacitors, parallel adds and series uses product over sum.
  • Putting electrolytics in series without balancing resistors. Leakage differences can push one past its rating.
  • Forgetting that each capacitor in parallel sees the whole voltage.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Common questions

How do capacitors add in series and parallel?

In parallel they add: 10 µF + 22 µF = 32 µF. In series use product over sum: (10 × 22) ÷ (10 + 22) ≈ 6.9 µF, which is smaller than either.

Why do capacitors combine opposite to resistors?

Parallel capacitors add plate area, which raises capacitance. Series capacitors are like a thicker gap between plates, which lowers it.