Tools / BJT common-emitter bias and gain

How to bias a BJT common-emitter amplifier and find its gain

A transistor amplifies only when it sits in the middle of its range. The bias network puts it there; then the gain follows from the collector current.

IB = (Vth − 0.7) ÷ (Rth + (β + 1)RE); IC = β × IB; VCE = Vcc − IC×RC − IE×RE; gain ≈ −gm × RC

Inputs

V
Ω
Ω
Ω
Ω
×

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Collector current
1.324 mA
Vce
7.755 V
Base voltage
2.032 V
Collector voltage
9.088 V
Gain re bypassed
-112.7
Gain re not bypassed
-2.158
Step by step

The working with your numbers

  1. Thevenin equivalent of the base dividerVth = Vcc × R2 ÷ (R1 + R2) = 2.11 V, Rth = R1 ∥ R2 = 8.25 kΩThis keeps the base current in the sum instead of ignoring it.
  2. Base currentIB = (Vth − 0.7) ÷ (Rth + (β + 1) × RE) = 1.41 ÷ 159 kΩ = 8.82 µA0.7 V is the base-emitter drop of a silicon transistor.
  3. Collector currentIC = β × IB = 150 × 8.82 µA = 1.32 mA
  4. Collector-emitter voltageVCE = Vcc − IC × RC − IE × RE = 12 − 2.91 − 1.33 = 7.76 V
  5. Voltage gaingm = IC ÷ 25.85 mV = 51.2 mS, gain = −gm × RC = −113 with RE bypassed; ≈ −RC ÷ (re′ + RE) = −2.16 withoutThe minus sign means the output is upside down compared with the input.

Does the answer make sense?

  • OK: VCE of 7.76 V leaves room for the signal to swing both ways.
  • OK: Aim for VCE ≈ Vcc ÷ 2 and for a divider current about ten times the base current, so the bias barely changes with β.

Common mistakes

  • Ignoring the base current when the divider is made of large resistors, which pulls the base voltage down.
  • Trusting the gain figure to better than 10 to 20 %: β and temperature vary from part to part.
  • Forgetting the coupling and bypass capacitors that let AC through without upsetting the bias.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Common questions

Why does divider bias keep a transistor stable?

The emitter resistor feeds back: more current raises the emitter voltage, which lowers the base-emitter voltage and trims the current. A stiff base divider makes the result nearly independent of β.

What is the gain of a common-emitter amplifier?

With the emitter resistor bypassed it is about −gm × RC, where gm = IC ÷ 25.85 mV at room temperature. Without the bypass it is about −RC ÷ (re′ + RE).