Idea
In short
How do you build an I2C over network cable test?
Send I2C over different lengths of twisted network cable with breakout jacks and find where it stops working. You need Arduino Nano, RJ45 jack (PCB) × 2, Rainbow ribbon cable (10 core), BME280 Environmental Sensor, Resistor 4.7 kΩ × 2 and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Test I2C over a cable.
Parts list
- Development Boards
- ConnectorsRJ45 jack (PCB) × 2
- Cables & Wires
- Sensors
- PassivesResistor 4.7 kΩ × 2
- Prototyping
How to build it
- Wire the two jacks
- Add the pull-ups
- Test at one metre
- Test at three metres
- Note where errors start
Common questions
What parts do I need for the I2C over network cable test?
Arduino Nano, RJ45 jack (PCB) × 2, Rainbow ribbon cable (10 core), BME280 Environmental Sensor, Resistor 4.7 kΩ × 2 and Breadboard 830 Tie Points.
How long does the I2C over network cable test take to build?
About 150 minutes for a intermediate maker.
