Idea
In short
How do you build a nucleo pressure trend gauge?
A Nucleo-64 board reads a BME280 and shows the air pressure with a trend arrow from the last three hours, a rough guide to changing weather. Not a forecast you should rely on for safety. You need STM32 Nucleo-64, BME280 Environmental Sensor, SSD1306 OLED Display and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 160 min
- Parts
- 4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Show whether the pressure is rising or falling.
Parts list
- Development Boards
- Sensors
- Displays
- Prototyping
How to build it
- Wire the sensor and display on I2C
- Read the pressure
- Store a reading every ten minutes
- Compare with three hours ago
- Draw a rising, steady or falling arrow
Common questions
What parts do I need for the nucleo pressure trend gauge?
STM32 Nucleo-64, BME280 Environmental Sensor, SSD1306 OLED Display and Breadboard 830 Tie Points.
How long does the nucleo pressure trend gauge take to build?
About 160 minutes for a intermediate maker.
