Idea
In short
How do you build an NEMA 23 first spin?
A larger stepper motor and a driver turn smoothly at set speeds, with the current set by the driver switches. Keep fingers away from the shaft. You need Arduino Nano, DM542 stepper driver, NEMA 23 stepper motor, 9 V battery, 9 V battery snap with DC jack, Flexible shaft coupler 5 mm to 8 mm and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Run a larger stepper safely.
Parts list
- Development Boards
- Motor Drivers
- Motors & Actuators
- Batteries
- Power
- Mechanical & Hardware
- Prototyping
How to build it
- Set the driver current from the motor label
- Wire the four motor leads
- Send step and direction pulses
- Ramp the speed
- Mount the shaft coupler
Common questions
What parts do I need for the NEMA 23 first spin?
Arduino Nano, DM542 stepper driver, NEMA 23 stepper motor, 9 V battery, 9 V battery snap with DC jack, Flexible shaft coupler 5 mm to 8 mm and Breadboard 830 Tie Points.
How long does the NEMA 23 first spin take to build?
About 240 minutes for a intermediate maker.
