Op-amp adder (summing) and subtractor (difference) amplifiers
To build an inverting summing amplifier and a difference amplifier and verify their outputs.
Theory
Summing amplifier with equal resistors: Vo = −(V1 + V2 + …). With unequal input resistors it gives a weighted sum: Vo = −Rf (V1/R1 + V2/R2). Difference amplifier with all four resistors equal: Vo = V2 − V1, where V2 goes to the non-inverting side.
Apparatus
- IC 741
- Resistors 10 kΩ × 6
- Dual supply ±12 V
- Two DC sources (or dividers from the supply)
- Multimeter
Circuit connections
- Adder: V1 → 10 kΩ and V2 → 10 kΩ, both to pin 2; Rf 10 kΩ from pin 2 to pin 6; pin 3 to ground
- Subtractor: V1 → 10 kΩ → pin 2; Rf 10 kΩ pin 2 to 6; V2 → 10 kΩ → pin 3; 10 kΩ from pin 3 to ground
Procedure
Pre-lab check
4 questions · 75% to be readyTry the readings before the lab
| V1 (V) | V2 (V) | Vo theory (V) |
|---|---|---|
| 1 | 1 | -2 |
| 1 | 2 | -3 |
| 2 | 0.5 | -2.5 |
| 3 | 2 | -5 |
| -1 | 2 | -1 |
| 0.5 | -1.5 | 1 |
Precautions
- Use resistors of the same tolerance (1% if available) for the subtractor.
- Keep outputs within the supply swing.
My readings
Type what you measured. It goes into your record book, and to My Garage when you are signed in.
| S. No. | V1 (V) | V2 (V) | Vo theory (V) |
|---|---|---|---|
| 1 | |||
| 2 | |||
| 3 | |||
| 4 | |||
| 5 | |||
| 6 |
Check my readings
Put the value you set in the first column, then compare. Real parts have tolerance.
Your lab record
Everything above is free. The print-ready write-up comes with Maker.
Printed pages leave the observation table empty for your own readings.
Viva practice
Say your answer out loud first, then check. The first 2 answers are free; Maker opens all 4.
Quick answers for your record and viva
What is the aim of the op-amp adder (summing) and subtractor (difference) amplifiers experiment?
To build an inverting summing amplifier and a difference amplifier and verify their outputs.
What apparatus is needed for op-amp adder (summing) and subtractor (difference) amplifiers?
IC 741, Resistors 10 kΩ × 6, Dual supply ±12 V, Two DC sources (or dividers from the supply), Multimeter.
What is the theory behind op-amp adder (summing) and subtractor (difference) amplifiers?
Summing amplifier with equal resistors: Vo = −(V1 + V2 + …). With unequal input resistors it gives a weighted sum: Vo = −Rf (V1/R1 + V2/R2). Difference amplifier with all four resistors equal: Vo = V2 − V1, where V2 goes to the non-inverting side.
What result should I get in op-amp adder (summing) and subtractor (difference) amplifiers?
The adder gives Vo = −(V1 + V2) and the subtractor Vo = V2 − V1, within ___ % of theory.
What precautions should I take in op-amp adder (summing) and subtractor (difference) amplifiers?
Use resistors of the same tolerance (1% if available) for the subtractor. Keep outputs within the supply swing.
