Instrumentation amplifier (three op-amp)
To build a three op-amp instrumentation amplifier and verify its gain for different values of Rg.
Theory
Two input buffers give very high input resistance; a difference amplifier rejects the common-mode signal. With equal resistors R in the first stage and a gain resistor Rg between them, and a unity-gain difference stage: Vo = (1 + 2R/Rg)(V2 − V1). Changing one resistor (Rg) sets the gain without upsetting the balance.
Apparatus
- IC LM324 (or three 741s)
- Resistors 10 kΩ × 7
- Potentiometer for Rg
- Dual supply ±12 V
- DC sources
Circuit connections
- V1 and V2 into the non-inverting inputs of A1 and A2; R from each output back to its inverting input; Rg between the two inverting inputs
- A1 and A2 outputs into a unity-gain difference amplifier (A3)
Procedure
Pre-lab check
4 questions · 75% to be readyTry the readings before the lab
| Rg (kΩ) | Gain | Vo (V) |
|---|---|---|
| 1 | 21 | 2.1 |
| 2.2 | 10.09 | 1.009 |
| 4.7 | 5.26 | 0.526 |
| 10 | 3 | 0.3 |
| 22 | 1.91 | 0.191 |
Precautions
- Match the resistors closely (1%) for good CMRR.
- Keep the inputs within the common-mode range.
My readings
Type what you measured. It goes into your record book, and to My Garage when you are signed in.
| S. No. | Rg (kΩ) | Gain | Vo (V) |
|---|---|---|---|
| 1 | |||
| 2 | |||
| 3 | |||
| 4 | |||
| 5 | |||
| 6 |
Check my readings
Put the value you set in the first column, then compare. Real parts have tolerance.
Your lab record
Everything above is free. The print-ready write-up comes with Maker.
Printed pages leave the observation table empty for your own readings.
Viva practice
Say your answer out loud first, then check. The first 2 answers are free; Maker opens all 4.
Quick answers for your record and viva
What is the aim of the instrumentation amplifier (three op-amp) experiment?
To build a three op-amp instrumentation amplifier and verify its gain for different values of Rg.
What apparatus is needed for instrumentation amplifier (three op-amp)?
IC LM324 (or three 741s), Resistors 10 kΩ × 7, Potentiometer for Rg, Dual supply ±12 V, DC sources.
What is the theory behind instrumentation amplifier (three op-amp)?
Two input buffers give very high input resistance; a difference amplifier rejects the common-mode signal. With equal resistors R in the first stage and a gain resistor Rg between them, and a unity-gain difference stage: Vo = (1 + 2R/Rg)(V2 − V1). Changing one resistor (Rg) sets the gain without upsetting the balance.
What result should I get in instrumentation amplifier (three op-amp)?
Gain follows 1 + 2R/Rg: for Rg = ___ kΩ, gain = ___ (theory ___). Common-mode output ≈ ___ mV.
What precautions should I take in instrumentation amplifier (three op-amp)?
Match the resistors closely (1%) for good CMRR. Keep the inputs within the common-mode range.
